Home/Industries

Industries

Valve selection is driven by the service: what flows through the line, at what pressure and temperature, and how the valve will be operated. The examples below show typical considerations. Final selection is always confirmed against your project data.

What influences valve selection

Medium

Water, steam, oil, gas, acids and slurries load a valve differently. Chloride-containing water attacks some stainless grades, and slurries with solids wear seats quickly. Body, seat and seal materials must suit the medium.

Pressure

The pressure class (PN or Class) must cover the maximum operating pressure plus surges. A pump discharge line, for example, sees higher pressure and water-hammer risk than a gravity line.

Temperature

Temperature affects material strength, seal choice and thermal expansion. A steam line needs materials rated for the temperature and for thermal cycling, while a chilled-water line mainly needs condensation to be considered.

Operating conditions

Frequency of operation, automation, fail-safe position and available space all matter. A valve that cycles often is better suited to quarter-turn operation with an actuator than to a manual handwheel.

Energy

Medium
Steam, condensate, boiler feedwater and cooling water.
Pressure
Boiler and steam lines run at higher pressure than cooling circuits, so the pressure class is chosen line by line.
Temperature
Hot steam and condensate need materials rated for the temperature and for thermal cycling.
Operating conditions
Start-up and shutdown cycles, and overpressure protection on boilers.
Typical valve choice
Globe valves for throttling, gate valves for isolation, safety valves on boilers and vessels, check valves on feedwater pump discharge, butterfly valves on cooling water.

Water & Wastewater

Medium
Raw and treated water, wastewater with solids, and dosing chemicals such as hypochlorite.
Pressure
Mostly low to moderate, with surge risk on pump discharge lines.
Temperature
Close to ambient. Frost protection can matter outdoors.
Operating conditions
Large line sizes, abrasive solids, chloride-containing water and infrequent operation.
Typical valve choice
Butterfly and gate valves for isolation on large lines, check valves on pumps, diaphragm valves for dosing and slurries.

Chemical

Medium
Acids, alkalis, solvents and other aggressive media.
Pressure
Varies widely with the process. Reactors and vessels need overpressure protection.
Temperature
Process temperatures can change quickly, so seal and body materials must tolerate the full range.
Operating conditions
Tight shut-off, material compatibility and, in hazardous service, a defined actuator fail position.
Typical valve choice
Ball valves with pneumatic or electric actuators for automated isolation, diaphragm valves for corrosive media, safety valves on vessels.

Industrial Process

Medium
Compressed air, process water, thermal oil, and food and beverage lines.
Pressure
Typically moderate and set by the utility system.
Temperature
From chilled water to hot utilities. Hygienic lines may also see cleaning cycles.
Operating conditions
Frequent automated switching, tight control of flow or temperature, and hygiene requirements in food service.
Typical valve choice
Actuated ball and butterfly valves for on/off duty, globe-type control valves for control loops, stainless-steel versions for hygienic lines.

Need a valve for your project?

Tell us the application and operating conditions. We will come back with a technical recommendation and a quotation.

Request a QuoteContact
EN
Request a Quote